Even if you don’t own a lot of sophisticated tools and equipment, you can easily produce great engines for your use. The Engine Analysis Software makes the process, possible and easy !
Tuning an engine using good fit, good time/area relationships and correct compression ratios is not difficult now!
Learning the procedures to build a top performing engine are EASY, using The Engine Analysis Software.
What are the chances of the average modeler “stumbling onto” the secrets of building a top performing engine, without The Engine Analysis Software?
NO CHANCE AT ALL !
The Engine Analysis Software includes many useful sections including:
- Calculation of Compression Ratios in Two Methods
- Conversion of Simple Measurements into Degrees of Duration
- Head Manufacturing Module
- Carb Sizing Module
- Time/Area Study Section
- Maximum Rod Angle Output
- Blow Down Degree Output
- Squish Velocity Calculations
- Open & Closing Points for Rotor or Crank Induction
- Tuned Pipe Builder
- And MUCH MORE
All outputs are automatically generated, after inputting, a few specific engine measurements.
You will immediately discover that small changes made using the Engine Analysis Software will yield HUGE performance increases.